Blown In Insulation in San Anselmo - Same-Day Service, Done Right the First Time

Fast, Reliable Blown In Insulation Across San Anselmo

Most blown-in insulation jobs in San Anselmo run $1,800 to $4,200 for a typical 1,200 to 1,800 square foot attic, depending on whether we’re topping off settled fill or starting fresh with air sealing. San Anselmo’s pre-1950 Craftsman homes and bungalows nearly always need a top-off plus air-seal approach rather than a simple depth fill, because the original joist cavities are shallow and the old venting lets wind scour the insulation bare along the eave line. We dispatch crews to San Anselmo daily from our Bay Area office, and a live person answers our phones around the clock at (254) 272-5876 when you call about an attic that’s running cold or a gas bill that keeps climbing. You’ll get a written price before any material comes off the truck, and a written 365-day guarantee that covers every inch of the install.

Call (254) 272-5876

Key Takeaways for San Anselmo Homeowners

• Blown-in insulation in San Anselmo typically runs $1,800 to $4,200 for a full attic top-off with air sealing, depending on square footage and how much old fill needs removal first.
• Most pre-1950 San Anselmo attics sit on 2×4 rafters with only 3 to 4 inches of joist cavity, so we top off and air seal rather than bury the framing.
• We respond to San Anselmo calls same day or next morning, with a background-checked, uniformed technician inside the scheduled window.
• Every job carries the 365-Day Done Right Promise: a written guarantee that if the work fails within a full year, we return and make it right at no charge.

Why Alden Attic Insulation Is San Anselmo’s Preferred Blown In Insulation Company

San Anselmo homeowners call us because we’ve been inside enough attics along Sir Francis Drake Boulevard and the streets climbing toward Sleepy Hollow to know what pre-1950 construction does to loose fill. The shallow 2×4 rafter bays, the original gable vents, the knob-and-tube wiring that was never disconnected, the can lights that a previous contractor buried under 14 inches of GreenFiber without sealing first. Alden Attic Insulation doesn’t just blow material and leave. Our Blown In Insulation technicians air-seal top plates, install baffles at the eave line, verify clearance around any remaining wiring, and document the final R-value in writing before we pack up. We’re part of the Garrison Partners family, established 2002, and every San Anselmo job runs under The Garrison Standard: written prices, written guarantees, and a crew that shows up inside the window it promised. Bryce Holloway, who runs our insulation division, holds every tech to that same line.

We also hear the same story from San Anselmo customers on a regular basis: a previous contractor quoted one number, showed up late, and left a mess in the attic that the homeowner didn’t discover for months. Our reviews from San Anselmo residents point to the opposite pattern: written quotes that didn’t move a dollar at invoice, a uniformed technician who walked the attic with the homeowner before and after, and a phone number that rings to a live person at any hour. When you schedule with us, you’ll know who is walking into your home and what they’re going to do before they climb the ladder.

Loose Fill Insulation in San Anselmo

Loose fill insulation is the standard approach for San Anselmo’s older attics because it flows around the irregular framing, shallow cavities, and leftover mechanical runs that a batt simply can’t cover cleanly. San Anselmo homes with original 2×4 rafters rarely have enough depth to hit modern R-value targets, so we blow to the maximum safe level while preserving attic ventilation, then air-seal the top plates and any penetrations so the fill stays put. A typical loose fill top-off in San Anselmo runs $1,800 to $3,200 for attics up to roughly 1,200 square feet, and includes removal of any badly settled material and installation of baffles at the eave and gable vents.

Air Sealing Before the Fill

Blowing insulation over unsealed top plates and can lights is the single most common mistake we find in San Anselmo attics. Air leaks push heat through the fill in winter, which is why a previous blown-in job can leave a bedroom cold even when the depth measures right. We seal every penetration with a proper fire-rated sealant or foam before any loose fill goes in.

Eave and Gable Vent Baffles

Older San Anselmo homes rely on passive ventilation through the original eave and gable gaps. If loose fill gets packed against those openings, the attic stops breathing and condensation forms on the underside of the sheathing. Our techs install baffles at every active vent bay before we blow, which keeps the air channel open and the fill exactly where it belongs.

Blown In Insulation Contractors in San Anselmo

Blown In Insulation Contractors in San Anselmo need to understand what a 1920s bungalow off San Anselmo Avenue actually looks like inside the attic: original 2×4 joists, old redwood siding breathing through a half-dozen gable cracks, and wiring that predates modern electrical code. That’s the job we train for. When a San Anselmo homeowner calls us, the first visit includes a full attic inspection, a moisture check around the vents, and a written plan that states exactly what we’re removing, what we’re sealing, and what R-value we’re leaving behind. Full blown-in installs with air sealing on larger San Anselmo homes in the hills above Seminary Drive or out toward Lansdale typically run $3,000 to $4,200, depending on access and how much old material has to come out first.

Top-Off and Correction Work

If a previous blow-in settled or wind-washed, we don’t always need to start from zero. We pull the bad sections, re-baffle the vents, and blow fresh loose fill to a uniform depth. This correction work usually falls between $900 and $2,200 in San Anselmo, and it’s where we spend a good share of our retainer calls.

Removal and Re-Blow

When knob-and-tube wiring is still live, or when a prior job packed loose fill tight against recessed cans and eave vents, the right move is full removal and a clean re-blow. We remove the old material with a HEPA-filtered vacuum, inspect every bay, and re-insulate to a uniform R-38 or better. San Anselmo removal-plus-re-blow jobs run $3,200 to $5,500 depending on square footage and debris condition.

Trusted Brands We Service in San Anselmo

We install and remove loose fill from brands you can research before we ever show up: GreenFiber, Owens Corning, Johns Manville, Knauf, and CertainTeed. For San Anselmo’s drafty pre-1950 attics, we most often recommend GreenFiber SANCTUARY for its dense-pack performance in shallow cavities and Owens Corning ProPink Loose Fill for top-off coverage over an air-sealed ceiling plane. You’ll see the exact product name and coverage spec on your written quote before you approve anything. That’s The Garrison Code: homeowners get to research the material going into their attic, not take our word for it.

Common Blown In Insulation Problems We See in San Anselmo Homes

• Wind-washed bare spots along eave and gable vents. San Anselmo’s older redwood-sided homes have wide original vent gaps that let the coastal air scouring up from the Lagunitas Creek drainage blow loose fill off the top plates. We see cold bands in the ceiling directly below these vents on almost every pre-1950 attic we inspect.
• Buried knob-and-tube wiring and unsealed can lights. A fast blown-in job buries the old wiring that many San Anselmo bungalows still carry in the attic, which creates a fire-safety issue and a code violation. We check every bay for live knob-and-tube before any material goes down.
• Packed-shut eave and gable vents. When loose fill from a previous job blocks the intentional venting that these Craftsman-era homes depend on, condensation and rot follow within a season or two. We re-baffle every active vent opening as part of a top-off.
• Settled fill that drops from R-38 to R-15. Loose fill compacts over the top plates in San Anselmo’s shallow 2×4 cavities, especially where footsteps from inspectors or cable techs compressed the material. Our techs measure depth in multiple bays and correct it to a uniform level before we call the job done.

Pricing for Blown In Insulation in San Anselmo, CA

We Also Serve Cities Near San Anselmo

Our Blown In Insulation in San Anselmo crews also run jobs in Fairfax, Kentfield, San Rafael, and Larkspur. If you’re in one of those towns and the attic is running cold, the same crew, the same written price, and the same 365-day guarantee apply. Call us and we’ll tell you straight when we can be there.

FAQs About Blown In Insulation in San Anselmo